Removal and Installation
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE INSTRUMENT CLUSTER FINISH PANEL
a. Remove the 2 clips.
b. Using a screwdriver, detach the 6 claws and remove the cluster finish panel.
HINT: Tape the screwdriver tip before use.
3. REMOVE COMBINATION METER ASSEMBLY
a. Remove the 3 screws.
b. Disconnect the connectors and remove the combination meter.
INSTALLATION
1. INSTALL COMBINATION METER ASSEMBLY
a. Connect the connectors and install the combination meter with the 3 screws.
2. INSTALL INSTRUMENT CLUSTER FINISH PANEL
a. Attach the 6 claws to install the cluster finish panel.
b. Install the 2 clips.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
5. CHECK SRS WARNING LIGHT
a. Check the SRS warning light.