Ignition Coil: Service and Repair
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-)battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE NO. 2 CYLINDER HEAD COVER
a. Remove the 4 cap nuts and head cover.
3. REMOVE IGNITION COIL ASSEMBLY
a. Disconnect the 4 ignition coil connectors.
b. Remove the 4 bolts and pull out the 4 ignition coils.
INSTALLATION
1. INSTALL IGNITION COIL ASSEMBLY
a. Install the 4 ignition coils with the 4 bolts.
Torque: 9.0 N.m (90 kgf.cm, 80 in.lbf)
b. Connect the 4 ignition coil connectors.
2. INSTALL NO. 2 CYLINDER HEAD COVER
a. Install the head cover with the 4 cap nuts.
Torque: 7.0 N.m (71 kgf.cm, 62 in.lbf)
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL