Sliding Roof ECU Power Source Circuit

SLIDING ROOF: SLIDING ROOF SYSTEM: Sliding Roof ECU Power Source Circuit

Sliding Roof ECU Power Source Circuit

DESCRIPTION

If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof ECU power source circuit.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM (IGNITION SWITCH SIGNAL)
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream ON.
(d) Enter the following menus: Body Electrical / Sliding Roof / Data List.
(e) According to the display on the Techstream, read the Data List.

Sliding Roof





OK:
The Techstream displays as shown in the table according to the operation of each switch.
NG -- INSPECT FUSE (SUNROOF, ECU-IG NO. 2)
OK -- REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
2. INSPECT FUSE (SUNROOF, ECU-IG NO. 2)





(a) Remove the SUNROOF and ECU-IG NO. 2 fuses from the main body ECU.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:






NG -- CHECK FOR SHORTS IN ALL HARNESSES AND CONNECTORS CONNECTED TO FUSE AND REPLACE FUSE
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (SLIDING ROOF DRIVE GEAR - BATTERY AND BODY GROUND)





(a) Disconnect the J3 drive gear connector.
(b) Measure the resistance and voltage according to the value(s) in the table below.
Standard Resistance:






Standard Voltage :






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)