Installation

U241E AUTOMATIC TRANSAXLE: TRANSMISSION WIRE: INSTALLATION

1. INSTALL TRANSMISSION WIRE

(a) Coat a new O-ring with ATF and install it into the transmission wire.





(b) Pass the transmission wire through the transaxle case.

(c) Install the transmission wire with the bolt.





Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(d) Coat the O-ring on the ATF temperature sensor with ATF.





(e) Install the ATF temperature sensor with the lock plate and bolt.

Torque : 6.6 Nm (67 kgf-cm, 58 in-lbf)

(f) Connect the 5 shift solenoid valve connectors.

2. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

(a) Install the 2 oil cleaner magnets onto the automatic transaxle oil pan sub-assembly, as shown in the illustration.





(b) Install the automatic transaxle oil pan sub-assembly and a new oil pan gasket with the 18 bolts.





Torque : 7.8 Nm (80 kgf-cm, 69 in-lbf)

3. ADD AUTOMATIC TRANSAXLE FLUID

Fluid type:

Toyota Genuine ATF WS

4. INSPECT AUTOMATIC TRANSAXLE FLUID Procedures

5. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK

6. INSTALL NO. 1 ENGINE UNDER COVER