Installation

BRAKE (REAR): REAR BRAKE FLEXIBLE HOSE: INSTALLATION

NOTICE:
* Because the rear flexible hoses LH and RH are not interchangeable, verify the part number when installing the flexible hoses.
* If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

HINT
* Use the same procedure for the LH side and RH side.
* The following procedure listed is for the LH side.

1. INSTALL REAR FLEXIBLE HOSE

(a) Install the rear flexible hose with 2 new clips.

NOTICE:
Install the clip as far as it will go.

(b) Using a union nut wrench 10 mm, connect the 2 brake tubes to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)

NOTICE:
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Service Precautions.

2. BLEED BRAKE LINE

Service and Repair

3. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)