Installation

BRAKE CONTROL: FRONT SPEED SENSOR: INSTALLATION

1. INSTALL FRONT SPEED SENSOR





(a) Install the speed sensor onto the steering knuckle with the bolt.

Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)

NOTICE:
* Check that the speed sensor tip and installation portion are free of foreign matter.
* Install the speed sensor without turning it from its original installation angle.

(b) Engage clamp C onto the shock absorber.

(c) Install the No. 1 sensor clamp onto the shock absorber with the bolt.

Torque : 29 Nm (296 kgf-cm, 21 ft-lbf)

NOTICE:
The bolt tightens the flexible hose and front speed sensor together. Make sure that the flexible hose is positioned over the front speed sensor.

(d) Install the No. 2 sensor clamp onto the body with the bolt.

Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)

(e) Engage clamp B onto the body.

(f) Connect the speed sensor connector.

(g) Engage clamp A onto the body.

2. INSTALL FRONT FENDER LINER Installation

3. INSTALL FRONT SIDE MUDGUARD Installation

4. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

5. INSPECT SPEED SENSOR SIGNAL

Test Mode Procedure