How Display and Read Diagnostic Trouble Codes

When on-board diagnosis of the A.B.S. control module detects a problem, the information (up to a maximum of three) will be stored in the EEP ROM as a trouble code. When there are more than three, the most recent three will be stored. (Stored codes will stay in memory until they are cleared.)

CALLING UP A TROUBLE CODE
1) Take out ABS. check connector from under side of steering column.
2) Turn ignition switch OFF.
3) Ground A.B.S. check connector terminal L.
4) Turn ignition switch ON.
5) A.B.S. warning light is set in the diagnostic mode and blinks to identify trouble code.
6) After the start code (11) is shown, the trouble codes will be shown in order of the last information first.
These repeat for a maximum of 5 minutes.





NOTE: When there are no trouble codes in memory, only the start code (11) is shown.