How to Use Subaru Select Monitor

HOW TO USE SUBARU SELECT MONITOR

1) Prepare Subaru select monitor and cartridge.





ST1 498307500 SELECT MONITOR KIT
ST2 498346700 CARTRIDGE

2) Turn ignition switch and Subaru select monitor switch to OFF.





3) Insert cartridge into Subaru select monitor.





4) Connect Subaru select monitor to data link connector.
- Using data link connector for Subaru select monitor only;
(1) Remove the A pillar lower trim of driver side front pillar.
(2) Connect Subaru select monitor to data link connector.
- Using data link connector for Subaru select monitor and OBD-II general scan tool:





(1) Connect ST to Subaru select monitor cable. ST 498357200 ADAPTER CABLE





(2) Open the cover and connect Subaru select monitor to data link connector located in the lower portion of the instrument panel (on the driver's side), to the lower cover.

CAUTION: Do not connect scan tools except for Subaru select monitor and OBD-II general scan tool.

5) Turn ignition switch ON (engine OFF) and Subaru select monitor switch ON.
6) Using Subaru select monitor, call up diagnostic trouble code(s) and various data, then record them.





7. FUNCTION MODE: F00
ROM ID NUMBER (YEAR)

CONDITION:
Ignition switch "ON"

SPECIFIED DATA:
Presentation display

- Probable cause (Item outside "specified data")