Inspection Mode

After performing diagnostics and clearing the memory, check for any remaining unresolved trouble data.
1) Prepare Subaru select monitor and cartridge.

ST1 498307500 SELECT MONITOR KIT
ST2 498346700 CARTRIDGE

2) Turn ignition switch and Subaru select monitor switch to OFF.





3) Insert cartridge into Subaru select monitor.
4) Remove the A pillar lower trim of driver side front pillar.





5) Connect diagnosis terminal into diagnosis connector (terminal No. 1).





6) Connect Subaru select monitor to data link connector.
- Using data link connector for Subaru select monitor only:
Connect Subaru select monitor to its data link connector located in the A pillar lower trim of driver side front pillar.
- Using data link connector for Subaru select monitor and OBD-II general scan tool:





(1) Connect ST to Subaru select monitor cable.

ST 498357200 ADAPTER CABLE





(2) Open the cover and connect Subaru select monitor to data link connector located in the lower portion of the instrument panel (on the driver's side), to the lower cover.

CAUTION: Do not connect scan tools except for Subaru select monitor and OBD-II general scan tool.





7) Turn ignition switch to ON (engine OFF) and Subaru select monitor switch to ON.
8) Start the engine.

NOTE: Ensure the selector lever is placed in the "P" position before starting.

9) Using the selector lever, turn the "P" position switch and the "N" position switch to ON.
10) Depress the brake pedal to turn the brake switch ON.
11) Keep engine speed in the 2,500-3,000 rpm range for 40 seconds.

NOTE: On models without tachometer, use the Subaru select monitor or tachometer (Secondary pickup type).

12) Place the selector lever in the "D" position and drive the vehicle at 5 to 10 km/h (3 to 6 MPH).

NOTE:
- Release the parking brake.
- The speed difference between front and rear wheels may light the ABS warning light, but this indicates no malfunctions. Turn ignition switch "OFF" to clear the memory.