Rear Wiper and Washer

1. BLADE




1. Pull out blade following the arrow direction, from arm while pushing up locking clip.
2. Installation is in the reverse order of removal.

2. WIPER ARM
1. Remove head cover.




2. Remove nut and wiper arm.
3. Installation is in the reverse order of removal.

NOTE: Remove metal sludge from the wiper arm fixture before installing it.

Tightening torque:
5.9 ± 1.5 N.m (0.6 ± 0.15 kg.m 4.3 ± 1.1 ft.lb)

3. WIPER MOTOR




1. Remove cap and special nut.

CAUTION: Be careful not to strike service tool against nozzle during removal.

Tightening torque:
7.4 ± 1.5 N.m (0.75 ± 0.15 kg.m 5.4 ± 1.1 ft.lb)

2. Remove rear gate trim.
3. Undo clips which secure harness, and disconnect connector of wiper motor.
4. Separate washer hoses at joint.




5. Remove attaching screws and take out wiper motor assembly.

CAUTION: Be careful not to damage O-ring when removing wiper motor assembly.

6. Installation is in the reverse order of removal.

Tightening torque:
5.9 ± 1.5 N.m (0.6 ± 0.15 kg.m, 4.3 ± 1.1 ft.lb)

4. WASHER TANK
1. Remove rear quarter trim.
2. Disconnect washer hose and connector.




3. Remove attaching bolts.
4. Installation is in the reverse order of removal.

Tightening torque:
5.9 ± 1.5 N.m (0.6 ± 0.15 kg.m, 4.3 ± 1.1 ft.lb)