Rear Wiper and Washer
Removal and Installation1. BLADE
1. Pull out blade following the arrow direction, from arm while pushing up locking clip (A).
2. Install in the reverse order of removal.
2. WIPER ARM
1. Remove head cover.
2. Remove nut and wiper arm.
3. Install in the reverse order of removal.
NOTE: Remove metal sludge from the wiper arm fixture before installing it.
Tightening torque: 7.8 ± 1.5 N.m (0.8 ± 0.15 kg-m, 5.8 ± 1.1 ft-lb)
3. WIPER MOTOR
1. Disconnect ground cable from battery.
2. Remove wiper arm.
3. Remove rear gate trim.
4. Undo clips which secure harness, and disconnect connector of wiper motor.
5. Remove attaching screws and take out wiper motor assembly.
CAUTION: Be careful not to damage O-ring when removing wiper motor assembly.
6. Install in the reverse order of removal.
Tightening torque: 5.9 ± 1.5 N.m (0.6 ± 0.15 kg-m, 4.3 ± 1.1 ft-lb)