Subaru Select Monitor (Normal Mode)

1. On the Main Menu display screen, select the {2. Each System Check} and press the [YES] key.
2. On the System Selection Menu display screen, select the (Engine Control System] and press the [YES] key.
3. Press the [YES] key after displayed the information of engine type.
4. On the Engine Diagnosis display screen, select the {Clear Memory} and press the [YES] key.
5. When the 'Done' and 'Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.

NOTE:
- After the memory has been cleared, the ISC must be initialized. To do this, turn the ignition switch to the ON position. Wait 3 seconds before starting the engine. (2500 cc models only)
- For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.