How to Use Subaru Select Monitor

Preparation Tool:

HOW TO USE SUBARU SELECT MONITOR






1. Prepare Subaru Select Monitor kit.
2. Connect diagnosis cable to Subaru Select Monitor.






3. Insert cartridge into Subaru Select Monitor.
4. Connect Subaru Select Monitor to data link connector.

a. Data link connector (A) located in the lower portion of the instrument panel (on the driver's side).
b. Connect diagnosis cable to data link connector.

CAUTION: Do not connect scan tools except for Subaru Select Monitor and OBD-II general scan tool.

5. Turn ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
6. Using Subaru Select Monitor, call up diagnostic trouble code(s) and various data, then record them.

READ DIAGNOSTIC TROUBLE CODE (DTC) FOR ENGINE (NORMAL MODE)
Subaru Select Monitor (Normal Mode)


READ DIAGNOSTIC TROUBLE CODE (DTC) FOR ENGINE (OBD MODE)
Subaru Select Monitor (OBD Mode)


READ CURRENT DATA FOR ENGINE (NORMAL MODE)
Current Data For Engine (Normal Mode)


READ CURRENT DATA FOR ENGINE (OBD MODE)
Current Data For Engine (OBD Mode)


REAR FREEZE FRAME DATA FOR ENGINE (OBD MODE)
Freeze Frame Data For Engine (OBD Mode)


REAR OXYGEN SENSOR MONITORING TEST RESULTS DATA FOR ENGINE (OBD MODE)
Read O2 Sensor Monitoring Test Results Data (OBD Mode)

LED OPERATION MODE FOR ENGINE
LED Operation Mode For Engine


READ CURRENT DATA FOR A/T
Current Data For AT