Removal and Installation
REMOVAL1) Loosen the wheel nuts, jack-up the vehicle, support it with rigid racks, and remove the wheel.
2) Release the parking brake.
3) Remove the brake drum from brake assembly.
4) Remove the brake shoe.
5) Unscrew the brake hose flare nut and disconnect the brake hose.
6) Remove the hub.
7) Disconnect the ABS sensor from back plate. (only vehicle equipped ABS)
8) Remove the brake assembly.
9) Remove the bolts installing the wheel cylinder on back plate, and remove it.
INSTALLATION
1) Clean the back plate and wheel cylinder.
2) Install the wheel cylinder on back plate, and tighten bolts.
Tightening torque: 10 Nm (1.0 kgf-m, 7.2 ft. lbs.)
3) Apply grease to the portions indicated by arrows in Figure.
Brake grease: Dow Corning Molykote No. 7439 (Part No. 725191460)
4) Install the brake assembly on housing, and tighten bolts to install the back plate.
Tightening torque: 53 Nm (5.4 kgf-m, 39.1 ft. lbs.)
5) Install the hub.
6) Connect the brake hose, and tighten the brake hose flange nut.
Tightening torque: 15 Nm (1.5 kgf-m, 10.8 ft. lbs.)
7) Connect the ABS sensor to back plate. (only vehicle equipped with ABS)
Tightening torque: 32 Nm (3.3 kgf-m, 24 ft. lbs.)
8) Apply grease to the adjusting screw and both ends of adjuster.
Brake grease: Dow Corning Molykote No. 7439 (Part No. 725191460)
9) Install the brake shoe.
10) Install brake drum.
11) After installing brake assembly, bleed air from brake line.