Flywheel: Service and Repair
A: REMOVAL1. Remove the transmission assembly.
2. Remove the clutch cover and clutch disc.
CAUTION:
^ Take care not to allow oil on the clutch disc facing.
^ Do not disassemble either the clutch cover or clutch disc.
3. Using ST, remove the flywheel.
ST 498497100 CRANKSHAFT STOPPER
B: INSTALLATION
1. Install the flywheel and ST.
ST4 98497100 CRANKSHAFT STOPPER
2. Tighten the flywheel attaching bolts to the specified torque.
NOTE: Tighten the flywheel installing bolts gradually. Each bolt should be tightened to the specified torque in a crisscross method.
Tightening torque: 72 Nm (7.3 kgf-cm, 52.8 ft. lbs.)
3. Install the clutch disc and cover.
4. Install the transmission assembly.