Disassembly and Assembly

DISASSEMBLY
1. Remove four washers and then detach rubber boot.





2. Remove bolts and then remove cable bracket and plate.
3. Twist the select lever grip and then remove select lever grip.





4. Detach indicator cover and pattern plate.
5. Disconnect solenoid assembly connector.





6. While pressing shift lock cancel button, remove shift lock solenoid assembly.





7. Remove illumination light.
8. Remove illumination bulb.





9. Remove illumination light cover.





10. Remove stopper.





11. Tilt lever forward and pull down to separate it from frame.





12. Remove clip, and "P"-position switch with harness.





13. Remove detent spring
14. Remove spring.

CAUTION: Wear goggles. Do not allow spring to fly out during removal.





15. Remove bolt and then disconnect lever upper and lever lower.

ASSEMBLY
1. Clean all parts before assembly.
2. Apply grease [MULTEMP AC-D or equivalent] to each parts.
3. Assembly is in the reverse order of disassembly.
4. After completion of fitting, transfer select lever to position "P"-"1", then check whether the indicator and select lever agree, whether operating force is.