Actuator Operation

Compulsory Valve Operation Check Mode

OPERATION




1. Prepare the Manufacturer's scan tool kit.
2. Connect the diagnosis cable to Manufacturer's scan tool.




3. Insert the cartridge into Manufacturer's scan tool.




4. Connect the test mode connector (A) at the lower portion of instrument panel (on driver's side).




5. Connect the Manufacturer's scan tool to data link connector located in the lower portion of instrument panel (on the driver's side).

CAUTION: Do not connect scan tools except for Manufacturer's scan tool and OBD II general scan tool.




6. Turn the ignition switch to ON (engine OFF) and Manufacturer's scan tool switch to ON.
7. On the Main Menu display screen, select the {2. Each System Check} and press the [YES] key.
8. On the System Selection Menu display screen, select the {Engine Control System} and press the [YES] key.
9. Press the [YES] key after the information of engine type is displayed.
10. On the Engine Diagnosis display screen, select the {System Operation Check Mode} and press the [YES] key.
11. On the System Operation Check Mode display screen, select the {Actuator ON/OFF Operation} and press the [YES] key.
12. Select the desired compulsory actuator on the Actuator ON/OFF Operation display screen and press the [YES] key.
13. Pressing the [NO] key completes the compulsory operation check mode. The display will then return to the Actuator ON/OFF Operation screen.




- A list of support data is shown in the table.






NOTE:
- The above mentioned parts will be displayed but not functional because they are not installed on the vehicle.
- For detailed operation procedure, refer to MANUFACTURER'S SCAN TOOL OPERATION MANUAL.