Transmission Temperature Sensor/Switch: Service and Repair

Shift Solenoids, Duty Solenoids and ATF Temperature Sensor

REMOVAL

SHIFT SOLENOIDS AND DUTY SOLENOIDS
1. Lift-up the vehicle.
2. Clean the transmission exterior.
3. Replace the gasket with a new one, and tighten the drain plug.





4. Drain the ATF completely.
Tightening torque: 25 Nm (2.5 kgf-m, 18 ft. lbs.)
5. Remove the oil pan.





6. Disconnect the solenoid and duty solenoid connectors.





7. Remove the solenoids and duty solenoids.

ATF TEMPERATURE SENSOR
For removal of ATF temperature sensor, refer to Front Vehicle Speed Sensor.

INSTALLATION

SHIFT SOLENOIDS AND DUTY SOLENOID ADS





1. Insert solenoid and duty solenoid to specified position.





2. Tighten the bolts and nuts.
Tightening torque: 8 Nm (0.8 kgf-m, 5.8 ft. lbs.)





3. Connect the harness connectors. Connect the connectors of same color, and secure the harness to valve body using clips.





4. Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)





5. Apply liquid gasket fully to three holes other than screw holes on transmission case.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020)

6. Install the oil pan.
Tightening torque: 5 Nm (0.5 kgf-m, 3.6 ft. lbs.)

7. Fill ATF up to the middle of the COLD side on level gauge by using the gauge hole.
8. Check the ATF level.

ATF TEMPERATURE SENSOR
For installation of ATF temperature sensor, refer to Front Vehicle Speed Sensor.