Gear Sensor/Switch: Service and Repair
Switches and HarnessREMOVAL
BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1. Disconnect the ground cable from battery.
2. Remove the air intake duct and cleaner case. (Non-turbo model)
3. Remove the intercooler. (Turbo model)
4. Disconnect the connector of back-up light switch and neutral position switch.
^ Non-turbo model
^ Turbo model
5. Lift-up the vehicle.
6. Remove the back-up light switch and neutral position switch with harness.
INSTALLATION
BACK-UP LIGHT SWITCH AND NEUTRAL POSITION SWITCH
1. Install the back-up light switch and neutral position switch with harness.
Tightening torque: 32.3 Nm (3.3 kgf-m, 23.8 ft. lbs.)
2. Connect the connector of back-up light switch and neutral position switch.
3. Install the air intake duct and cleaner case. (Non-turbo model)
4. Install the intercooler. (Turbo model)
5. Connect the battery ground cable to battery.
INSPECTION
BACK-UP LIGHT SWITCH
Inspect the back-up light switch.
NEUTRAL POSITION SWITCH
1. Turn the ignition switch to OFF.
2. Disconnect the connector of neutral position switch.
3. Measure the resistance between neutral position switch terminals.
Non-turbo model
Turbo model
^ Non-turbo model
^ Turbo model
4. Replace defective parts.