With Manufacturer's Scan Tool
Clear Memory ModeOPERATION
1. SUBARU SELECT MONITOR (NORMAL MODE)
1. On Main Menu display screen, select the {2. Each System Check} and press the [YES] key.
2. On System Selection Menu display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On Engine Diagnosis display screen, select the {Clear Memory} and press the [YES] key.
5. When the "Done" and "Turn Ignition Switch OFF" are shown on display screen, turn the ignition switch to OFF, and then turn the Subaru Select Monitor to OFF.
NOTE: For detailed operation procedure, refer to SUBARU SELECT MONITOR OPERATION MANUAL.
2. SUBARU SELECT MONITOR (OBD MODE)
1. On Main Menu display screen, select the {2. Each System Check} and press the [YES] key.
2. On System Selection Menu display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On �Engine Diagnosis� display screen, select the {OBD System} and press the [YES] key.
5. On OBD Menu display screen, select the {4. Diagnosis Code(s) Cleared} and press the [YES] key.
6. When the "Clear Diagnostic Code?" is shown on the display screen, press the [YES] key.
7. Turn the Subaru Select Monitor and ignition switch to OFF.
NOTE: For detailed operation procedure, refer to SUBARU SELECT MONITOR OPERATION MANUAL.