Without Scan Tool

Clear Memory Mode

OPERATION
1. On the Main Menu display screen, select {Each System Check}.
2. On the System Selection Menu display screen, select {Engine}.
3. Select the [OK] after the information of engine type is displayed.
4. On the Engine Diagnosis display screen, select {Clear Memory}.
5. When "Done" is shown on the display screen, turn the ignition switch to OFF, and then Subaru Select Monitor switch to OFF.

NOTE:
- After the memory has been cleared, the idle air control solenoid valve must be initialized. To execute this procedure, turn the ignition switch to ON. Wait for three seconds before starting the engine.
- For detailed operation procedure, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL". Subaru Select Monitor