Read Diagnostic Trouble Code (DTC)

READ DIAGNOSTIC TROUBLE CODE (DTC)
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to the Subaru Select Monitor.
3) Connect the Subaru Select Monitor to the data link connector.
(1) Data link connector is located in the lower portion of instrument panel (on the driver's side).





(2) Connect the diagnosis cable to the data link connector.

NOTE: Do not connect scan tools except for Subaru Select Monitor or OBD-II general scan tool.

4) Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
5) On the �Main Menu� display screen, select the {Each System Check}.
6) On the �System Selection Menu� display screen, select the {Transmission}.
7) Select the [OK] after the information of transmission type is displayed.
8) On the �Transmission Diagnosis� screen, select {DTC Display}.

NOTE:
^ For details concerning operation procedures, refer to the "SUBARU SELECT MONITOR OPERATION MANUAL".
^ For details concerning DTC, refer to "List of Diagnostic Trouble Code (DTC)". List of Diagnostic Trouble Code (DTC)