Output Shaft Oil Seal
Oil SealREPLACEMENT
1) Clean the transmission exterior.
2) Drain gear oil completely.
NOTE:
^ Tighten the drain plug after draining the gear oil.
^ Use a new gasket.
3) Remove the rear exhaust pipe and muffler.
4) Remove the heat shield cover. (If equipped)
5) Remove the propeller shaft.
6) Using the ST, remove the oil seal.
ST 398527700 PULLER ASSY
7) Using the ST, install the oil seal.
ST 498057300 INSTALLER
8) Install the propeller shaft.
9) Install the heat shield cover. (If equipped)
10) Install the rear exhaust pipe and muffler.
11) Fill the gear oil and check the oil level.