Antitheft Motion Sensor: Description and Operation
OPERATION1. IMPACT SENSOR SETTING USING SUBARU SELECT MONITOR
1. Prepare the Subaru Select Monitor kit.
2. Prepare PC with Subaru Select Monitor installed.
3. Connect USB cable to SDI (Subaru Diagnostic Interface) and PC USB port (Subaru Select Monitor dedicated port).
NOTE: Subaru Select Monitor dedicated port indicates USB port used when installing Subaru Select Monitor.
4. Connect the diagnosis cable to SDI.
5. Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION: Do not connect scan tools other than the Subaru Select Monitor.
6. Start a PC.
7. Turn the ignition switch to ON (engine OFF), and start "PC application help for Subaru Select Monitor".
8. On the System Selection Menu, select the {Integ. Unit mode}.
9. Select {ECM customizing}.
10. Make a impact monitor setting.
- When installing: ON
- When removing: OFF
11. Make a impact monitor ON/OFF setting.
- When installing: ON
- When removing: OFF
12. Turn the ignition switch to OFF, and then remove the Subaru Select Monitor.