Programming and Relearning
FACILITATION OF LEARNING CONTROLNOTE:
- Follow the messages displayed on the Subaru Select Monitor when working.
- When the following work is performed, perform learning control for the transmission.
Replacement of TCM/Replacement or disassembly of transmission assembly/Replacement of control valve body/Performing "Clear Memories 2" is executed.
1. Warm up or cool down until the ATF temperature displayed on the Subaru Select Monitor is 60 - 80°C (140 - 176°F).
2. Shift the select lever to "P" range.
3. Fully apply the parking brake.
4. Lift up the vehicle.
CAUTION: Be sure to keep the lowest edge of the tires 30 cm or more off the ground because the vehicle vibrates during the work.
5. Connect the Subaru Select Monitor to data link connector.
6. Turn the ignition switch to ON.
7. Turn off all switches causing an electrical load, such as headlights, A/C, seat heater and rear defogger.
8. On vehicles equipped with an ECO switch, turn the ECO switch to ON. On vehicles equipped with an SPORT mode, turn the SPORT mode OFF. On vehicles equipped with an POWER/HOLD switch, turn the POWER/HOLD switch to OFF. On vehicles equipped with SI-DRIVE, set to I mode.
NOTE: Error message is not displayed even when an incorrect mode is set. While the operation is continued, "AT learning promoting" is displayed, but it cannot end normally. If the message does not change after 2 minutes have passed, retry "AT learning mode" from the beginning.
CAUTION: Do not turn the power of the Subaru Select Monitor OFF and do not disconnect the data link connector during the operation.
9. Select (AT related learning/inspection model in the [[Transmission Diagnosis]] screen of the Subaru Select Monitor.
10. Select (AT learning model in the [[AT related learning/inspection mode]] screen of the Subaru Select Monitor.
11. Follow the messages displayed on the Subaru Select Monitor screen when working.
NOTE: During AT learning in progress, SPORT indicator light in the combination meter starts flashing at 2 Hz and the learning operation starts. The following message is displayed on the screen when the SPORT indicator light turns off.
12. AT simple learning is complete when the message "AT learning normally ended" is displayed.
NOTE:
- If a communication error occurs during learning, restart the "AT learning mode" over from the beginning.
- If the message "Execute AT learning again after fixing troubles of the vehicle" is displayed during learning, select [OK] to display the List of Diagnostics Trouble Code. After repairing the locations indicated by the DTC, start the "AT learning mode" over from the beginning.
- If the message "AT learning ended abnormally" is displayed, start the "AT learning mode" over from the beginning.
- When communication error occurs during learning, select lever does not shift occasionally. If select lever does not shift, turn the ignition to OFF and operate the lever.
- For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".