Removal and Replacement

Headlight Assembly

REMOVAL

CAUTION:
- Do not perform work with wet hands.
- The HID headlight uses very high voltages for the lighting circuit. Make sure that the power is turned OFF before working.

1. Disconnect the ground cable from battery.
2. Remove the clips and remove the air intake duct (rear). (When removing the headlight RH).






3. Remove the front bumper face.
4. Disconnect harness connectors.
5. Remove the three bolts, disengage the clip, then detach the headlight assembly.






INSTALLATION
Install in the reverse order of removal.

Tightening torque: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)