Trunk / Liftgate Switch: Service and Repair
Rear Gate Opener ButtonREMOVAL
NOTE: The rear gate opener button is integrated into the license plate light assembly harness.
1. Remove the rear gate trim.
2. Remove the rear gate garnish.
3. Loosen four screws to remove the rear gate garnish lower cover.
4. Hold down the hook of the rear gate opener button, and remove the rear gate opener button.
5. Remove the license plate light.
6. Remove the license plate light assembly harness.
INSTALLATION
CAUTION:
- Install with the band tightened point of switch harness facing towards the vehicle
- Make sure that the harness grommets are installed securely. If not properly installed, this may cause leaks.
Install in the reverse order of removal.