M/T - Revised Transfer Driven Gear Bearings

NUMBER: *03-69-12R*
DATE: 09/10/12
*REVISED: 12/11/12*

APPLICABILITY:
2013MY and later Legacy and Outback w/ 6MT

SUBJECT:
6MT Transfer Driven Gear Bearing

INTRODUCTION

This bulletin reviews a change to the part numbers used for the transfer driven gear bearings. These revised bearings are to be used to enhance durability. Changes to the tools required and supplemental procedures for the installation of these bearings are also covered.

COUNTERMEASURE IN PRODUCTION

The updated bearings were incorporated into production starting with transmission Number 686951.





PART INFORMATION

IMPORTANT:
When replacing the old part number bearings with the new, the front and rear bearings must be replaced together as a "set". Do Not mix old and new style bearings together on the gear. In addition, take care to not mix them up during the repair process as they are very similar in appearance.





SPECIAL TOOL INFORMATION





SERVICE PROCEDURE / INFORMATION

*IMPORTANT:
Only the tool numbers shown above should be used to perform the installation procedure.*

After installing the new bearings on the transfer driven gear using the proper tools, apply 1g (.035oz.) of grease on the roller bearings as shown in the above photos. Install the gear assembly into the transfer case and rotate the shaft to spread the grease throughout the front bearing rollers evenly. Repeat the procedure for the rear bearing in the extension housing. Follow the remaining procedures as outlined in the applicable Service Manual.

Grease: Nichimoly N130 or Conoco-Phillips Multiplex Red # 2 grease

WARRANTY / CLAIM INFORMATION

For vehicles within warranty, refer to Subaru Warranty Wizard(R) for claim
submission information.