Water Pump Removal and Installation
Water Pump Removal and InstallationRemoval
1) Disconnect negative (-) cable at battery.
2) Drain coolant.
3) Remove accessory drive belt.
4) Remove front bumper.
5) Remove condenser cooling fan.
^ Manual A/C model:
^ Auto A/C model:
6) Remove oil level gauge and oil level gauge guide.
7) Remove exhaust manifold.
8) With hose connected, detach A/C compressor from cylinder block.
^ Manual A/C model:
^ Auto A/C model:
9) Disconnect radiator outlet hose from water pump.
10) Remove inlet pipe (2) from water pump (1) and cylinder block.
11) Remove water pump (1) from cylinder block.
Installation
Reference: Water Pump Inspection
Reverse removal procedure for installation noting the following points.
^ Use new gasket and O-ring.
^ Install water pump assembly to cylinder block and tighten bolts to specified torque.
Tightening torque
Water pump bolt (a): 25 Nm (2.5 kg-m, 18.5 lbf-ft)
^ Refill cooling system.
^ Verify that there is no coolant leakage at each connection.