Rear Wheel Hub Assembly Removal and Installation (Rear Disc Brake Model)

Rear Wheel Hub Assembly Removal and Installation (Rear Disc Brake Model)

Removal
1) Hoist vehicle and remove rear wheel.
2) Pull up parking brake lever.
Uncaulk rear drive shaft nut (1) and then remove rear drive shaft nut (1) (4WD model).





3) Remove rear brake caliper assembly and rear brake disc.
4) Disconnect wheel speed sensor connector (1) (4WD model).
5) Remove wheel speed sensor (4) (2WD model).
6) Remove brake dust cover (2) and rear wheel hub assembly (3) from rear axle.








7) Remove stud bolts from rear wheel hub assembly referring to Step 6) under "Removal" of Rear Wheel Hub Assembly Removal and Installation (Rear Drum Brake Model), if necessary.

Installation

CAUTION:
Rear hub bolt is pre-coated with friction stabilizer.
Never reuse the removed bolt. Otherwise, bolt may loosen.

1) Install stud bolts to rear wheel hub assembly referring to Step 1) under "Installation" of Rear Wheel Hub Assembly Removal and Installation (Rear Drum Brake Model), if removed.
2) Install rear brake dust cover (1), rear wheel hub assembly (2) and then tighten new rear hub bolts to specified torque.

Tightening torque
Rear hub bolt (a): 73 Nm (7.3 kg-m, 53.0 lbf-ft)

3) Connect wheel speed sensor connector (3) (4WD model).
4) Install wheel speed sensor (4) and tighten wheel speed sensor bolt to specified torque (2WD model).

Tightening torque
Wheel speed sensor bolt (b): 11 Nm (1.1 kg-m, 8.0 lbf-ft)








5) Install rear brake disc and rear brake caliper assembly.
6) Pull up parking brake lever.

For 4WD model, tighten new rear drive shaft nut to specified torque.
7) Install wheel and tighten wheel nuts to specified torque.
8) Adjust parking brake cable.
9) Upon completion of installation, perform brake test.