Passenger Air Bag (Inflator) Module Repair Harness Installation
Passenger Air Bag (Inflator) Module Repair Harness InstallationReplace passenger air bag (inflator) module repair harness (2) according to the following procedure when the harness (9) connected with passenger air bag (inflator) module of the air bag harness included in instrument panel harness (7) and passenger air bag (inflator) module connector (1) is damaged.
1. Disable air bag system. Refer to Disabling Air Bag System:Advanced Air Bag.
2. Remove passenger air bag (inflator) module referring to Passenger Air Bag (Inflator) Module Removal and Installation:Advanced Air Bag if it has installed.
3. Disconnect floor harness joint (yellow) connector (1) with passenger air bag (inflator) module of air bag harness included in instrument panel harness from floor harness located near the glove box.
4. Cut off passenger air bag (inflator) module connectors (1) and floor harness joint (yellow) connector (2) with passenger air bag (inflator) module of air bag harness included in instrument panel harness as shown, and then fasten it to instrument panel harness with vinyl tape for avoiding interference with other parts.
5. Fix passenger air bag (inflator) module repair harness (1) to instrument panel harness (2).
CAUTION: To avoid interference with other parts, fasten the repair harness to instrument panel harness with a clamp (3) as shown in figure.
6. Connect passenger air bag (inflator) module repair harness connector (4) to floor harness securely till click is heard.
7. Install passenger air bag (inflator) module referring to Passenger Air Bag (Inflator) Module Removal and Installation:Advanced Air Bag.
8. Enabling air bag system referring to Enabling Air Bag System:Advanced Air Bag.
9. Confirm that there is no DTC detected to SDM with ignition switch turned ON.