B1091

DTC B1081 / B1082 / B1085 / B1091 / B1092 / B1095

DTC Detecting Condition and Trouble Area






Circuit Diagram










DTC Troubleshooting


1. Was "Air Bag Diagnostic System Check" performed?
YES
Go to Step 2.
NO
Go to Air Bag Diagnostic System Check Air Bag Diagnostic System Check.
2. DTC check
Confirm that ignition mode of keyless push start system is in "OFF".
Connect scan tool to DLC.
Push engine switch to change ignition mode of keyless push start system to "ON".
Check if any of following DTC is output.
B1083 or B1084 (DTC B1081, B1082 or DTC B1085)
B1093 or B1094 (DTC B1091, B1092 or DTC B1095)
Is relevant DTC output?
YES
Go to applicable DTC diag. flow.
NO
Go to Step 3.
3. Side impact sensor check
Substitute a known-good side impact sensor and recheck DTC. Removal and Installation
Is DTC detected?
YES
Substitute a known-good SDM and recheck DTC. SDM Removal and Installation
NO
End.

NOTE:

Upon completion of inspection and repair work, perform the following items.

- Reconnect all air bag system components and ensure all components are properly mounted.
- Clear DTCs, referring to DTC Clearance DTC Clearance
if any DTC is detected.
- Repeat Air Bag Diagnostic System Check Air Bag Diagnostic System Check
to confirm that the trouble has been solved.