Removal and Replacement

Headlight Unit Removal and Installation

CAUTION:

Touching a hot bulb may cause a burn.

Do not touch any bulb when it is hot.

NOTE:

If you touch the glass surface of a bulb with your bare hand, the oils from your skin can cause the bulb to overheat and burst when the lights are on.

Do not touch any bulb when removing the headlight housing.

Removal

1) Disconnect negative (-) cable at battery.
2) Remove headlight cover (1).





3) Remove front bumper. Service and Repair
4) Disconnect headlight unit connectors.
5) Remove headlight unit bolts (1) and clip.
6) Remove headlight holder (2) and headlight unit (3).





7) Remove clips and remove headlight holder (1) from headlight unit (2).





8) Remove bulbs, if necessary.

NOTE:
Bulbs in headlight unit except bulb for left low-beam light can be replaced from rear side with headlight unit installed.









9) Turn back cover counterclockwise to remove.
10) Disconnect headlight bulb connector (HI) (1).
11) Pull out clearance bulb socket (2) and remove clearance bulb.
12) Release bulb spring and remove headlight bulb (HI) (3).






Installation

Reverse removal procedure, noting the following points.

- Align headlight bulb (LO) projection (1) with housing grooves (2).





- Aim headlights after installing. Adjustments