Rear Wiper Motor Inspection

Rear Wiper Motor Inspection

Rear Wiper Removal and Installation

NOTE:

Make sure that battery voltage is 12 V or more.

1) Make a mark (1) on rear wiper motor (2) stop position as shown.





2) Check rear wiper motor for operation as follows.
- For motor operation
a Connect battery positive terminal to terminal "1" and its negative terminal to terminal "2".
b Check if motor reciprocation speed is as specification. If check result is not as specified, replace motor.

Specification
35 - 45 r/min (rpm)





- For automatic stop operation
a Connect battery positive (+) terminal to terminal "1" and its negative (-) terminal to terminal "2" and let the motor turn.
b Disconnect terminal "2" from battery negative (-) terminal and let the motor stop.
c Observe the motor (4) turns once again then stops at a specified position as shown.











d Repeat Step a. to c. several times and check that the motor stops at the specified position every time.
If check result is not satisfied, replace motor.