Rear View Monitor System (w/ Navigation System)

PARK ASSIST / MONITORING: REAR VIEW MONITOR SYSTEM (w/ Navigation System): HOW TO PROCEED WITH TROUBLESHOOTING

HINT
Use the following procedure to troubleshoot the rear view monitor system.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard voltage:

11 to 14 V

If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

NEXT -- Continue to next step.

3. CHECK AND CLEAR DTCs

(a) Refer to DTC Check/Clear of the navigation system Reading and Clearing Diagnostic Trouble Codes.

NEXT -- Continue to next step.

4. PROBLEM SYMPTOM CONFIRMATION

Result





B -- Go to step 6
A -- Continue to next step.

5. SYMPTOM SIMULATION

NEXT -- Continue to next step.

6. CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM

(a) Refer to the navigation system Problem Symptoms Table.

Result





B -- GO TO NAVIGATION SYSTEM How to Proceed With Troubleshooting
A -- Continue to next step.

7. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table Problem Symptoms Table.

Result





B -- Go to step 9
A -- Continue to next step.

8. PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

(a) Terminals of ECU Rear View Monitor System (w/ Navigation System)

NEXT -- Continue to next step.

9. ADJUST, REPAIR OR REPLACE

NEXT -- Continue to next step.

10. CONFIRMATION TEST

NEXT -- END