With A132L Automatic Transaxle

1. Disconnect battery ground cable, then disconnect neutral safety switch electrical connector and wire harness clamp.
2. Disconnect speedometer cable, then remove throttle cable from throttle link.
3. Disconnect starter cable and electrical connector, then the starter attaching bolts and starter.
4. Remove upper side attaching bolts, then raise and support vehicle.
5. Drain transaxle fluid, then the differential fluid.
6. Disconnect oil cooler hose from pipe, then remove engine under cover.
7. Remove clip from control cable, then disconnect control cable from lever.
8. Remove drive shafts, then the six torque converter attaching bolts. Rotate crankshaft to gain access to each bolt.
9. Disconnect bond cable from LH engine mounting bracket, then remove LH mounting attaching bolts and LH mount.
10. Support engine and transaxle with two suitable jacks, then remove four support bolts and disconnect rear mount bracket from body. Remove three bolts and engine rear mounting bracket.
11. Remove transaxle mount bolts, then separate torque converter from transaxle.
12. Reverse procedure to install.