Removal and Installation

Front Brake Components:

REMOVAL





1. Disconnect flexible hose.
(a) Remove the union bolt and 2 gaskets from the Caliper, then disconnect the flexible hose from the Caliper.
Torque: 29 Nm (21 ft. lbs.)

NOTE: Install the flexible hose lock securely in the lock hole in the Caliper.

(b) Use a container to catch the brake fluid as it drains out.
2. Remove Caliper.
(a) Hold the sliding pin and loosen the 2 installation bolts, and remove the installation bolts.
Torque: 34 Nm (25 ft. lbs.)
(b) Remove the Caliper from the torque plate.
3. Remove these parts:
(a) 2 anti-squeal springs.
(b) 2 Brake Pads with anti-squeal shims.
(c) 2 4 pad support plates.

INSTALLATION
Installation is in the reverse order of removal.

NOTE: After installation, fill brake reservoir with brake fluid, bleed brake system. Service and Repair
- Check for leaks.