Removal and Installation

Rear Disc Brake Components:

REMOVAL

Removing Union Bolt And Gaskets:

1. Disconnect flexible hose.
(a) Remove the union bolt and 2 gaskets from the Caliper, then disconnect the flexible hose from the Caliper.
Torque: 29 Nm (22 ft. lbs.)

NOTE: Insert the flexible hose lock securely in the lock hole in the Caliper.

(b) Use a container to catch the brake fluid as it drains out.
2. Remove Caliper.
(a) Hold the sliding pin and loosen the 2 installation bolts.
Torque: 34 Nm (25 ft. lbs.)
(b) Remove the installation bolts.
(c) Remove the Caliper from the torque plate.
3. Remove these parts:
(a) 2 Brake Pads with anti-squeal shims.
(b) 4 pad support plate.

CAUTION: There should be no oil or grease adhering to the friction surfaces of the pads or Disc.

INSTALLATION
Installation is in the reverse order of removal.

NOTE: After installation, fill brake reservoir with brake fluid, bleed brake system. Service and Repair
- Check for leaks.