Heated Oxygen Sensor (Bank 1 Sensor 2)

INSPECT HEATER RESISTANCE OF HEATED OXYGEN
SENSOR (Bank 1, Sensor 2)

a. Column shift:
Remove the passenger's seat.

b. Floor shift:
Take out the console box side of the floor carpet.

c. Disconnect the oxygen sensor connector.




d. Using an ohmmeter, measure the resistance between the terminals +B and HT.

Resistance:
11 - 16 Ohms at 20°C (68°F)

If the resistance is not as specified, replace the sensor.

Torque: 44 N.m (440 kgf.cm, 31 ft.lbf)

e. Reconnect the oxygen sensor connector.

f. Floor shift:
Reinstall the floor carpet.

g. Column shift:
Reinstall the passenger's seat.