Floor Shift
Removal w/Floor Shift
NOTE: Do not open the cover or the case of the ECU and various electrical devices unless absolutely necessary.
(If the IC terminals are touched, the IC may be destroyed by static electricity.)
1. REMOVE FRONT SEAT
2. REMOVE UPPER CONSOLE PANEL
3. REMOVE REAR CONSOLE BOX
4. REMOVE CENTER CLUSTER FINISH PANEL
5. REMOVE LOWER FINISH PANEL ASSEMBLY
6. REMOVE LOWER No. 2 FINISH PANEL
7. REMOVE GLOVE COMPARTMENT DOOR
8. REMOVE GLOVE COMPARTMENT
9. REMOVE FRONT CONSOLE BOX
Remove Airbag Sensor Assembly:
10. REMOVE AIRBAG SENSOR ASSEMBLY
a. Disconnect the airbag sensor connectors.
NOTE: Remove the connectors with the airbag sensor assembly installed.
Remove Airbag Sensor Assembly:
b. Using a torx wrench, remove the 4 screws and airbag sensor assembly.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
HINT: Lift up the floor carpet and loosen the screw.
Installation
NOTE:
- Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
- Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
- Never repair a sensor in order to reuse it.
Remove Airbag Sensor Assembly:
1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a torx wrench, install the airbag sensor assembly with 4 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
Torque: 20 Nm (200 kgf.cm, 15 ft.lbf)
HINT: Lift up the floor carpet and torque the screw.
b. Connect the airbag sensor connectors.
NOTE:
- Installation of the connector is done after the sensor assembly has been installed.
- Make sure the sensor assembly is installed with the specified torque.
- If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor assembly with a new one.
- When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
- After installing , shake the sensor assembly to check that there is no looseness.
2. INSTALL REMOVED PARTS