Blower Motor Resistor: Testing and Inspection

INSPECTION
1. REMOVE GLOVE COMPARTMENT PARTS




2. REMOVE BLOWER RESISTOR
a. Disconnect the connector.
b. Remove the 2 screws and blower resistor.







3. INSPECT BLOWER RESISTOR RESISTANCE
Measure resistance between terminals, as shown in the chart below.
If resistance is not as specified, replace the blower resistor.

4. INSTALL BLOWER RESISTOR
a. Install the blower resistor with the 2 screws.
b. Connect the connector.

5. INSTALL GLOVE COMPARTMENT PARTS