Replacement Requirements
THROTTLE BODYREPLACEMENT
NOTE:
- Do not give a shock to the throttle position sensor.
- Do not disassemble or adjust the throttle opener.
1. REPLACE THROTTLE POTION SENSOR
a. Remove the 2 screws and throttle position sensor.
b. Reinstall a new throttle position sensor.
1. Check that the throttle valve is fully close.
2. Insert the sensor to the throttle body with it turned counterclockwise by 300 to 600 against the fully close valve position.
3. By turning the sensor clockwise, tighten the 2 screws.
2. REPLACE IAC VALVE
a. Remove the 4 screws, bracket, IAC valve and gasket.
b. Place a new gasket on the No.1 throttle body.
c. Reinstall a new IAC valve with the 4 screws and bracket.
3. REPLACE THROTTLE BODIES
a. Remove the 2 screws and protector.
b. Remove the 6 screws, No.1 throttle body, No.2 throttle body and 2 gaskets from the No.1 intake air control valve.
c. Place 2 new gaskets and 2 new O-rings as shown in the illustration.
d. Reinstall a new No.1 throttle body and No.2 throttle body with the 6 screws.
Torque: 6.9 N.m (70 kgf.cm, 61 in.lbf)