First and Reverse Brake

INSPECTION





1. INSPECT DISC, PLATE AND FLANGE
Check if the sliding surfaces of the discs, plates and flange are worn or burnt.
If necessary, replace them.

HINT:
^ If the lining of the disc is peeling off or discolored, or even if a part of the printed numbers are defaced, replace all discs.
^ Before assembling new discs, soak them in ATF for at least 15 minutes.





2. CHECK 1ST & REVERSE BRAKE RETURN SPRING
Using a vernier calipers, measure the free length of the spring together with the spring seal.
Standard free length: 22.58 mm (0.8890 inch)