Cylinder Head Assembly: Specifications
CYLINDER HEADFor Cylinder Head specifications and tightening procedures, please refer to the procedures provided at Cylinder Head Assembly; Service and Repair. Service and Repair
CYLINDER HEAD SET BOLT
Standard outside diameter: 10.85 to 11.00 mm (0.4272 to 0.4331 inch)
Minimum outside diameter: 10.7 mm (0.421 inch)
INTAKE MANIFOLD
Install and tighten the 10 bolts uniformly in several steps.
Torque: 21 Nm (214 kgf-cm, 15 ft. lbs.)
CAMSHAFT BEARING CAP
Temporarily tighten the 8 bolts in the order shown in the illustration.
Torque: 10 Nm (102 kgf-cm, 7 ft. lbs.)
EXHAUST MANIFOLD LH
Install the exhaust manifold sub-assembly RH with the 6 nuts.
Torque: 21 Nm (214 kgf-cm, 15 ft. lbs.)
EXHAUST MANIFOLD RH
Install the exhaust manifold sub-assembly RH with the 6 nuts.
Torque: 21 Nm (214 kgf-cm, 15 ft. lbs.)