Factory Installed Keyless Entry
REPLACEMENT1. REGISTRATION OF RECOGNITION CODE
HINT:
- The add mode is used to retain already registered codes while registering new recognition codes. This mode is used when adding a transmitter. If the number of registered codes exceeds 4, previously registered codes will be correspondingly erased in order, starting from the first registered code.
- The rewrite mode is used to erase all the previously registered codes and register only new recognition codes. This mode is used when exchanging the transmitter or the door control receiver with new one.
- The prohibition mode is used to erase all the registered codes and cancels the wireless door lock function. Use this mode when the transmitter is lost.
- The confirmation mode is for confirming how many recognition codes have already been registered before an additional registration of a recognition code.
a. The vehicle should be in the following conditions.
1. The key is not inserted in the ignition key cylinder.
2. The driver side door glass is fully opened.
3. Driver's door is OPENED. (The other doors are CLOSED)
4. Driver's door is UNLOCKED. (The other doors are locked)
b. Select a mode.
1. Insert and remove the key from the ignition key cylinder twice within 5 seconds.
2. After the above operations, close and open the driver door twice.
3. Insert the key into the ignition key cylinder and remove it.
4. Close and open the driver door twice.
5. Insert the key plate into the ignition key cylinder and close the driver side door.
6. To select a mode, turn the ignition switch from ON to LOCK at approximately 1 second intervals according to the number of times shown.
NOTE: If the number of the ON-LOCK operation of the ignition switch is 4 or more than 5, the registration will end without any signs.
7. Within 3 seconds after a mode has been selected, the theft warning ECU automatically performs LOCK-UNLOCK operation to inform the operator which mode has been selected.
HINT:
- When the confirmation mode has been selected and 0 codes are registered, LOCK-UNLOCK operation is automatically performed 5 times.
- When the confirmation mode has been selected and LOCK-UNLOCK operation has been performed twice as shown in the illustration, the number of the registered recognition codes is 2.
HINT: If the prohibition mode and confirmation mode are selected, the registration mode ends.
c. Registration of transmitter:
1. Within 40 seconds after the add mode or the rewrite mode has been selected, press the LOCK and UNLOCK switches twice.
NOTE: Press and hold both switches for 1 second or more during each press. However, the time between the 1st press and the 2nd press must be under 3 seconds.
2. LOCK-UNLOCK operation is automatically performed once within 3 seconds after above operation (step 1), when the recognition code of the transmitter has been registered correctly. If the LOCK-UNLOCK operation is performed twice, the registration of the recognition code has failed. In this case, register the recognition code from the beginning of the registration procedures once again.
3. Within 3 seconds after the transmitter switch has been turned OFF; the LOCK-UNLOCK operation will be automatically performed once if the registration of the recognition code of the transmitter is completed correctly. In case the LOCK-UNLOCK operation is performed twice, the registration of recognition code has failed. Perform the registration procedure from the beginning once again.
4. When continuing the registration, register the transmitter within 40 seconds after the previous registration.
HINT: 4 type recognition codes can be registered at one time.
d. If even one of the following conditions is satisfied, registration of recognition codes is completed.
1. 40 seconds have elapsed under the condition that the registration mode is ready.
2. The driver's door is opened.
3. The key plate is inserted in the ignition key cylinder.
4. 4 type recognition codes are registered at one time.