Inspections

ON-VEHICLE INSPECTION

1. FUNCTION CHECK
a. Check that the key reminder warning buzzer will sound.
1. With the driver's door close, insert the key into the ignition switch lock cylinder, and then turn the key to the LOCK or ACC.
2. Then, check that the buzzer will sound intermittently if the driver's door is opened.

b. Check that the key reminder warning buzzer will stop.
1. Check that the buzzer will stop if any of the following operations is done while the buzzer is sounding.
- Close the driver's door (front door courtesy lamp switch assembly is off).
- Turn the ignition switch ON.
- Pull out the key from the ignition switch lock cylinder.

2. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (BODY ECU) (LEFT SIDE)
a. Disconnect the B6 body ECU connector.







b. Check the continuity of the connector terminal.
If the continuity is not as specified, there may be a malfunction in the vehicle's side.




c. Reconnect the connector.
d. Check the voltage of the connector terminal.
If the value is not as specified, the instrument panel J/B may malfunction.

3. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (BODY ECU) (REAR SIDE)

a. Disconnect the 2F and 2G connectors.







b. Check the voltage or continuity between the connector terminals.
If the value is not as specified, there may be a malfunction on the wire harness side.