Rear Left Sensor

Air Bag Sensor Rear LH:

REPLACEMENT

HINT: Replacement procedure of the RH side is the same as that for the LH side.

1. PRECAUTION
Observe Air Bag Systems; Service Precautions.
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE REAR SEAT CUSHION ASSEMBLY
4. REMOVE REAR SIDE SEAT BACK ASSEMBLY LH




5. REMOVE AIR BAG SENSOR REAR LH
a. Disconnect the connector from the airbag sensor rear LH.
b. Remove the 2 bolts and the airbag sensor rear LH.

6. INSTALL AIR BAG SENSOR REAR LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.

NOTE: After removing the terminal wait for at least 90 seconds before starting the operation.

c. Install the airbag sensor rear LH with the 2 bolts.

Torque:
Property class 6T: 17. 5 N.m (178 kgf.cm, 13 ft.lbf)
Property class 8T: 20 N.m (200 kgf.cm, 14 ft.lbf)

HINT: Select a suitable bolt.

NOTE:
- If the airbag sensor rear LH has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace the airbag sensor rear LH with a new one.
- When installing the airbag sensor rear LH, be careful that the SRS wiring does not interfere with other parts and is not pinched between other parts.

d. Connect the connector to the airbag sensor rear LH.
e. Check that there is no looseness in the installation parts of the airbag sensor rear LH.

7. INSPECT AIR BAG SENSOR REAR LH
8. INSTALL REAR SIDE SEAT BACK ASSEMBLY LH
9. INSPECT SRS WARNING LIGHT