Rear Left Sensor

Air Bag Sensor Rear LH:

AIRBAG SENSOR REAR LH

REPLACEMENT

HINT: Use the same procedures for the RH side and LH side.

1. PRECAUTION
Refer to Air Bag Systems; Service Precautions.
2. DISCONNECT BATTERY NEGATIVE TERMINAL

CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.

3. REMOVE REAR DOOR SCUFF PLATE LH
4. REMOVE REAR DOOR OPENING TRIM LH
5. REMOVE REAR SEAT BACK HINGE COVER
6. REMOVE REAR SEAT BACK HINGE SUB-ASSEMBLY LH
7. REMOVE REAR SEAT ASSEMBLY LH
8. REMOVE REAR SEAT SIDE GARNISH LH




9. REMOVE AIR BAG SENSOR REAR LH
a. Disconnect the connector from the airbag sensor rear LH.
b. Remove the nut and the airbag sensor rear LH.

10. INSTALL AIR BAG SENSOR REAR LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.

CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.

c. Install the airbag sensor rear LH with the nut.

Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)

NOTE:
- If the airbag sensor rear LH has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
- When installing the airbag sensor rear LH, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

d. Check that there is no looseness in the installation parts of the airbag sensor rear LH.
e. Connect the connector to the airbag sensor rear LH.

11. INSTALL REAR SEAT SIDE GARNISH LH
12. INSTALL REAR SEAT ASSEMBLY LH
13. INSTALL REAR SEAT BACK HINGE SUB-ASSEMBLY LH
14. INSTALL REAR SEAT BACK HINGE COVER
15. INSTALL REAR DOOR OPENING TRIM LH
16. INSTALL REAR DOOR SCUFF PLATE LH
17. CONNECT BATTERY NEGATIVE TERMINAL
18. INSPECT SRS WARNING LIGHT