C1281

DTC C1281/81 MASTER CYLINDER PRESSURE SENSOR OUTPUT SIGNAL IS FAULTY (TEST MODE DTC)

CIRCUIT DESCRIPTION

DTC Detecting Condition:

The master cylinder pressure sensor is connected to the skid control ECU in the actuator.

DTC C1281/81 is output only in the test mode (SIGNAL CHECK).

Step 1-2:

INSPECTION PROCEDURE

NOTE: When replacing the ABS & TRACTION actuator assembly, perform zero point calibration. Calibration

HINT: Start the inspection from step 1 when using the hand-held tester and start from step 2 when not using the hand-held tester.