Seat Position Sensor
SEAT POSITION SENSORREMOVAL
HINT: Installation is in the reverse order of removal.
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT LH SEAT ASSEMBLY
3. REMOVE SLIDE & VERTICAL POWER SEAT SWITCH KNOB (for Power Seat)
4. REMOVE RECLINING POWER SEAT SWITCH KNOB (for Power Seat)
5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Power Seat)
6. REMOVE FRONT SEAT CUSHION SHIELD INNER NO.1 LH (for Power Seat)
7. REMOVE FRONT SEAT CUSHION SHIELD LH (for Power Seat)
8. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)
9. REMOVE VERTICAL SEAT ADJUSTER KNOB (for Manual Seat)
10. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (for Manual Seat)
11. REMOVE VERTICAL ADJUSTING HANDLE NO.2 (for Manual Seat)
12. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat)
13. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR
a. Remove the seat slide position sensor protector from the seat position airbag sensor.
14. REMOVE SEAT POSITION AIRBAG SENSOR
a. Disconnect the connector from the seat position airbag sensor.
b. Using a torx socket wrench (T30), remove the torx screw and the seat position airbag sensor.
INSTALLATION
1. INSTALL SEAT POSITION AIRBAG SENSOR
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.
CAUTION: After removing the terminal, wait for at least 90 seconds before starting the operation.
c. Using a feeler gauge 1 mm (0.039 in.), install the seat position airbag sensor.
NOTE:
- If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace the seat position airbag sensor with a new one.
- When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with other parts and is not pinched between other parts.
HINT: Be sure to maintain a clearance between the seat position airbag sensor and the seat rail is within 0.6 mm (0.023 in.) to 2 mm (0.079 in.).
d. Using a torx socket wrench, tighten the torx screw to install the seat position airbag sensor.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
e. Make sure that a clearance between the seat position airbag sensor and the seat rail is within 0.6 mm (0.023 in.) to 2 mm (0.079 in.).
f. Connect the connector to the seat position airbag sensor.
g. Check that there is no looseness in the installation parts of the seat position airbag sensor.
2. INSTALL FRONT LH SEAT ASSEMBLY
3. CONNECT BATTERY NEGATIVE TERMINAL
NOTE: When disconnecting the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.
System Name
Power Window Control System
Sliding Roof System
4. INSPECT SRS WARNING LIGHT